Push the crown in two ‘clicks’ to the closed position next to the case. Turn the crown clockwise to move the Second hand to the ‘12:00’ position. The Second hand will move indicating the Second hand can now be set. Turning the crown rapidly (‘clicking’ continuously two or more times) causes the hand to advance continuously until the crown is again turned. Turn the crown clockwise or counterclockwise so that Function hand points to ‘SUN’ and the date is set for 1. The Function hand will move indicating that is the hand that can now be set. Turning the crown rapidly (‘clicking’ continuously two or more times) causes the hands to advance continuously until the crown is again turned. Turn the crown clockwise or counterclockwise to set Hour, Minute hands to 12:00 and the Function hand to ‘24’ (the 24 Hour hand moves in conjunction with the Hour hand and cannot be set independently.) The Minute hand will move to indicate the Hour, Minute and 24 Hour hands can be set. Following a confirmation tone, each of the hands performs a ‘demonstration’ in the order of the Function, Minute and Second hands to indicate that the ‘all reset’ of the movement has completed. Press the upper right (A) and lower right (B) buttons simultaneously for two to three seconds, then release.
When the hands have stopped moving, pull the crown out two ‘clicks’. Push the crown back in one ‘click’ to the closed position next Turn the crown so that either tip of the Mode hand is pointing to the Local Time mode (L-TM) ALL RESET and 0-POSITIONING CORRECTION PROCEDURE Press the upper right button (A) to resume normal operation in the Local Time mode. If any of the hands do not indicate their respective 0-position, it will be necessary to perform the all reset and 0-positioning correction procedure. Function hand pointing to ‘SUN’ -Date indicating ‘1’ Hour, Minute and Second hand pointing to ’12:00’ -24 Hour hand pointing to ‘24’ The correct 0-position for each hand is as follows: Press the upper right button (A) for 10 or more seconds until the hands move to the 0-position stored in memory. Push the crown back in one ‘click’ to the closed position next to the case. Turn the crown so that either tip of the Mode hand is pointing to the Local Time mode (L-TM). If it is not moving in one-second increments, be sure to charge your watch fully as outlined in your Instruction Manual. The second hand on this watch moves in one-second increments to indicate that the charge level is sufficient for normal time keeping operation. If the hands and date do not move to their respective 0- positions, it will be necessary to set them for proper operation.Īfter a full recharge from complete power loss or if abnormal operation is noted, an ALL RESET and 0- POSITIONING CORRECTION will be needed. If you suspect a malfunction, first check the 0-position of the hands as outlined in the 0-positioning check procedure.
0 kommentar(er)
